Tomoko

  • Total activity 424
  • Last activity
  • Member since
  • Following 0 users
  • Followed by 0 users
  • Votes 0
  • Subscriptions 359

Activity overview

Latest activity by Tomoko
  • Tomoko created an article,

    Please let me know about the operation of connection retry count.

    Question Please let me know about the operation of "connection retry count" described in the "GUI User's Manual". When performing a connection retry, how may seconds after which occasion will the n...

  • Tomoko created an article,

    What kind of operational scenario does the no-communication detection time function assume?

    Question What kind of operational scenario does the no-communication detection time function described in the "GUI User's Manual" assume? Answer This is a function that assumes cases where a cost i...

  • Tomoko created an article,

    Performing a mobile connection test

    If establishing a mobile connection using a SIM, perform a connection test for the mobile line in advance to make sure that the connection can be made successfully. Target devices AG series AR ser...

  • Tomoko created an article,

    Configuring time correction using the NTP server on the Internet

    This recipe explains how to configure time correction using the NTP server on the Internet. Table of contents How to configure time synchronization with the NTP server by using the GUI How to conf...

  • Tomoko created an article,

    Sending an e-mail when a camera is disconnected from Nx Witness

    This recipe explains the settings configured to send an e-mail to a destination you wish when a camera is disconnected from Nx Witness.   Target device AG10/20 Preparation To enable Nx Witness to...

  • Tomoko created an article,

    Enabling remote.it (CLI)

    This recipe explains the procedure for enabling remote.it on your device. Target devices AG10 AR10 *To use remote.it, you will need to apply to use it in advance. *To use remote.it, you wil...

  • Tomoko created an article,

    Additional information of each mobile setting item

    In detailed configuration mode of mobile settings, you can control a mobile connection by specifying the connection time and the connection count. Setting examples I want to automatically swith th...

  • Tomoko created an article,

    Setting the camera rules for Nx Witness

    This recipe explains the procedure for setting the camera rules for the Nx Witness Desktop Client.   Setting the camera rules Launch the Nx Witness Desktop Client, right-click the target camera, ...

  • Tomoko created an article,

    Setting the IP address on the LAN side

    Question Please let me know how to set the IP address for the device connected to LAN0-3. Target device AG10/20 Answer LAN0-3 are bridged to Interface br0 by default. With the following commands,...

  • Tomoko created an article,

    Setting the DHCP server

    This recipe explains the procedure for setting the DHCP server. DHCP server A DHCP server is a server that automatically issues the necessary information such as IP addresses to devices connected ...