Tomoko
- Total activity 820
- Last activity
- Member since
- Following 0 users
- Followed by 0 users
- Votes 0
- Subscriptions 424
Articles
Recent activity by Tomoko-
Configuring time correction using the NTP server on the Internet
This recipe explains how to configure time correction using the NTP server on the Internet. Table of contents How to configure time synchronization with the NTP server by using the GUI How to conf...
-
Sending an e-mail when a camera is disconnected from Nx Witness
This recipe explains the settings configured to send an e-mail to a destination you wish when a camera is disconnected from Nx Witness. Target device AG10/20 Preparation To enable Nx Witness to...
-
Enabling remote.it (CLI)
This recipe explains the procedure for enabling remote.it on your device. Target devices AG10 AR10 *To use remote.it, you will need to apply to use it in advance. *To use remote.it, you wil...
-
Setting the camera rules for Nx Witness
This recipe explains the procedure for setting the camera rules for the Nx Witness Desktop Client. Setting the camera rules Launch the Nx Witness Desktop Client, right-click the target camera, ...
-
Setting the IP address on the LAN side
Question Please let me know how to set the IP address for the device connected to LAN0-3. Target device AG10/20 Answer LAN0-3 are bridged to Interface br0 by default. With the following commands,...
-
Example of configuring static routing
This recipe explains the procedure for configuring static routing. Static route Static routing is a method for defining routing information to send traffic to a specific address through a fixed ro...
-
Schedule alive monitoring for PoE-enabled cameras
Question Please let me know how to schedule alive monitoring for PoE-enabled cameras connected to LAN0-3. Target devices AG10 AG20 Answer For the AG10/AG20 series, by combining the keep-alive ali...
-
About a limit to the number of connections that can be made from the initiator side of remote.it at the same time
Question For remote.it, is there a limit to the number of connections that can be made from the initiator side (connection source) to one target device (connection destination) at the same time? ...
-
I want to automatically switch the SIM to the other one if the communication is interrupted.
Question What settings do I need to configure if I want to operate the SIM under the following conditions? Under normal circumstances, establish a permanent connection with SIM0. If any of the fo...
-
Backup and restoration of the whole system
Overview This section explains how to back up and restore the whole system (whole OS). Target devices AG10/20 AR10/20 Precondition It is recommended to have knowledge of the following item: Ba...